Internal Coating, Powerkote PKSX Powdered Lubricant (8oz)

POWERKOTE� PKSX POWDERED LUBRICANT

• Designed to treat surfaces that either cannot be coated with a liquid lubricant or for parts that cannot be oven-cured.
  • Load-carrying capabilities in excess of 350,000 p.s.i.
  • Bonds at 20-millionths-of-an-inch thick. Requires no clearance changes.
  • Functional lubrication up to 1500�F.
  • Can be applied over dry film lubricants.
  • Fluid retaining, compatible with petroleum-based and synthetic oils.
• Designed for cylinder walls, lifter bores, and valve guides.
• Extreme temperature and pressure lubricant.
• Reduces friction and wear.
• Improve ring seal.
• No curing/baking required.
  • Simply buff on.
• Can be cleaned/removed with solvents such as alcohol.

Part #PKSX available in 1-ounce & 8-ounce bottles. Retail packaging.

APPLICATION:
Clean metal using standard cleaning methods with Columbia Coatings Super Degreaser (SD-MTO25) and you can even use a pressure washer with injector for the cleaner. Make sure the parts are rinsed well from chemical then blow the part of after washing. Let parts dry and then repeat process with a Non-Petroleum Solvent Based cleaner such as acetone, lacquer thinner or other similar non-petroleum based solvent. When the surface is clean and dry, apply a thin even layer of coating using an a an air brush or touch up spray gun such as Columbia Coatings Ceramic Application Gun (CCAG2) or equivalent system that allows for application of a thin film build of approximately .001� to .0015. Avoid excessive build-up of material as this can lead to loss of adhesion. DO NOT APPLY A SECOND COAT AFTER THE COATING DRIES. Allow to air dry and Cure at 300f for 1 hour.

CLEAN UP: Clean equipment with water

DANGER: Non Flammable

READ DATA SHEET AND SDS BEFORE USING